Set up zyxel travel router in client bridged mode Tom's hardware thread where this was discussed Solution update: To enable Client mode (to bridge my existing wifi network to Ethernet), follow these steps: Flip the switch on the ZyXEL's side to AP mode. Log in to the ZyXEL's setup page @ 192.168.100.1 (the directions recommend giving your computer a static IP address first, 192.168.100.10) From the sidebar, click Wireless>Basic Settings Look for the "wireless mode" setting halfway down; click where it says "AP" and pick "Client" from the dropdown menu and then click "apply" From the sidebar, click Wireless>Site Survey Click the Site Survey button on this page to refresh the list of wifi networks in range. Click the bubble to the right of your network, and then the Next button to get the password screen Match your encryption method, key length, and type of password. Click finish, and if you typed in your password and settings riiiight... You're done!